ADTRAN 1000R Series caller-id override [always <number>

Command Reference Guide BRI Interface Configuration Command set

caller-id override [always <number> | if-no-cid <number>]

Use the caller-id override command to configure the unit to replace caller ID information with a

user-specified number. Use the no form of this command to disable any caller ID overrides.

Syntax Description

always <number> Always forces replacement of the incoming caller ID number with the number

given.

if-no-cid <number> Replaces the incoming caller ID number with the number given only if there is no

caller ID information available for the incoming call.

Default Values

By default, this command is disabled.

Applicable Platforms

This command applies to the NetVanta 1000R, 3000, and 4000 Series units.

Command History

Release 6.1 Command was introduced.

Functional Notes

This command forces a replacement of the in coming caller ID number with the number given. The re ceived

caller ID, if any, is discarded, and the given override number is used to connect the incoming call to a

circuit of the same number.

Usage Examples

The following example configures the unit to always provide the given number as the caller ID number:

(config)#interface bri 1/2

(config-bri 1/2)#caller-id override always 5551000