Command Reference Guide SHDSL Interface Configuration Command Set
61200510L1-35E Copyright © 2005 ADTRAN 685

SHDSL INTERFACE C ONFIGURATION COMMAND SET

To activate the SHDSL Interface Configuration mode, enter the interface shdsl command at the Global
Configuration mode prompt. For example:
>enable
#
configure terminal
(config#)
interface shdsl 1/1
(config-shdsl 1/1)#
The following comm a nd s are com mo n to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <“text”> on page 27
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
description <text> on page 31
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
alarm-threshold [loop-attenuation | snr-margin] <value> on page 686
boot alternate-image on page 687
equipment-type [co | cpe] on page 688
inband-detection on page 689
inband-protocol [pn127 | v54] on page 690
linerate <value> on page 691
loopback network on page 692
loopback remote on page 693
loopback remote inband on page 694
outage-retrain on page 695
test-pattern [clear | insert | 2^15 | show] on page 696