ADTRAN 1000R Series T1 INTERFACE CONFIGURATION COMMAND SET

Command Reference Guide T1 Interface Configuration Command Set

T1 INTERFACE CONFIGURATION COMMAND SET

To activate the T1 Interface Configuration mode, enter the interface t1 command at the Global

Configuration mode prompt. For example:

>enable

configure terminal

(config)#

interface t1 1/1

(config-t1 1/1)#

The following comm a nd s are com mo n to multiple command sets and are covered in a centralized section

of this guide. For more information, refer to the sections listed below:

alias <“text”> on page 27

cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>

on page 28

description <text> on page 31

do on page 32

end on page 33

exit on page 34

shutdown on page 35

All other commands for this command set are described in this section in alphabetical order.

clock source [internal | line | through | throug h <interface id>] on page 698

coding [ami | b8zs] on page 699

fdl [ansi | att | none] on page 700

framing [d4 | esf] on page 701

lbo [long <-22.5, -15, -7.5, 0> | short <0-655>] on page 702

loopback commands begin on page 703

remote-alarm [rai] on page 706

remote-loopback on page 707

show test-pattern on page 708

snmp trap line-status on page 709

snmp trap link-status on page 710

snmp trap threshold-reached on page 711

tdm-group <group number> timeslots <1-24> speed [56 | 64] on page 712