ADTRAN 1000R Series show mac address-table static

Command Reference Guide Enable Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 257
show mac address-table static
Use the show mac address-table static command to display all static medium access control (MAC)
addresses known by the AOS.
Variations of this command include the following:
show mac address-table static
show mac address-table static address <mac address>
show mac address-table static address <mac address> interface <interface type> <interface id>
show mac address-table static address <mac address> interface <interface type> <interface id>
vlan <vlan id>
show mac address-table static address <mac address> vlan <vlan id>
show mac address-table static interface <interface type> <interface id>
show mac address-table static interface <interface type> <interface id> vlan <vlan id>
show mac address-table static vlan <vlan id>
Syntax Description
address <mac address> Specifies a valid 48-bit MAC address.
interface <interface type> Shows information for a specific interface. Type show mac address-table
static interface ? for a list of valid interfaces.
<interface id> Specifies any valid slot/port interface ID (e.g., 0/1).
vlan
<vlan id> Specifies a valid VLAN interface ID (1 to 4094).
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, and 1000R Series units.
Command History
Release 5.1 Command was introduced.