Command Reference Guide Router (OSPF) Configuration Command Set
61200510L1-35E Copyright © 2005 ADTRAN 1301

ROUTER (OSPF) CONFIGURATION COMMAND SET

To activate the Router (OSPF) Configuration mode, enter the router ospf command at the Global
Configuration mode prompt. For example:
>enable
#
configure terminal
(config)#
router ospf
(config-ospf)#
The following comm a nd s are com mo n to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
do on page 32
cross-connect <#> <from interface> <slot/port> <tdm-group#> < to interface> <slot/port>
on page 28
end on page 33
exit on page 34
All other commands for this command set are described in this section in alphabetical order.
area <area id> default-cost <value> on page 1302
area <area id> range <ip address> <network mask> [advertise | not-advertise] on page 1303
area <area id> stub [n o-summary] on page 1 304
auto-cost reference-bandwidth <rate> on page 1305
default-information-originate [always | metric <value> | metric-type <type>] on page 1306
default-metric <value> on page 1307
maximum paths <number> on page 1308
network <ip address> <wildcard> area <are a id> on page 1309
redistribute connected [metric <value> | metric-type <type> | subnets] on page 1310
redistribute rip [metric <value> | metric-type <type> | subnets] on page 1311
redistribute static [metric <value> | metric-type <type> | subnets] on page 1312
summary-address <address> <mask | prefix mask> not-advertise on page 1313
timers lsa-group-pacing <seconds> on page 1314
timers spf <delay> <hold> on page 1315