ADTRAN 1000R Series switchport access vlan <vlan id>

Command Reference Guide Port Channel Interface Config Command Set

switchport access vlan <vlan id>

Use the switchport access vlan command to se t the port to be a member of the VLAN when in access

mode. To reset the port to be a member of the default VLAN, use the no version of this command.

Syntax Description

<vlan id> Specifies a valid VLAN interface ID (1 to 4094).

Default Values

By default, this is set to VLAN 1 (the default VLAN).

Applicable Platforms

This command applies to the NetVanta 300, 1000, and 1000R Series units.

Command History

Release 5.1 Command was introduced.

Functional Notes

If the port is in the trunk mode, this command will not alter the switchport mode to access. Instead it will

save the value to be appl ied when th e port does switch to access mode. Refer to switchport mode [access

| trunk] on page 1032 for more information.

Usage Examples

The following example sets the switchport mode to static-access and makes the port channel 1 port a

member of VLAN 2:

(config)#interface port-channel 1

(config-p-chan 1)#switchport mode access

(config-p-chan 1)#switchport access vlan 2