ADTRAN 1000R Series bandwidth [percent | remaining

Command Reference Guide Quality of Service (QoS) Map Commands

bandwidth [percent | remaining | <value> ]

Use the bandwidth command to provide the bandwidth value of an interface to the higher-level protocols.

This value is used in cost calculations. Use the no form of this command to restore the default values.

Syntax Description

percent Specifies percent of total interface bandwidth.

remaining Specifies percent of total interface bandwidth minus any priority entry bandwidth

values on this QOS map.

<value> Specifies the bandwidth value in kbps. Valid range is from 8 to 20000 00

Default Values

By default, there is no bandwidth configured for a QOS map entry.

Applicable Platforms

This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900

Series units.

Command History

Release 9.1 Command was introduced.

Release 10.0 New subcommands percent and remaining were added.

Functional Notes

When configuring entries within a QOS map set in Rev. 10, there are a few rules to be aware of:

1. The unit s of the bandwidth (kbps, percent, or remaining percent) must be consistent for all class-based

entries (use the bandwidth command) in a QOS map set.

2. The total bandwidth between all priority entries and class-based entries in a QOS map set should not

be configured beyond 75 pe rcen t of th e bandwidth on the interface that the qos-policy is applied to, or

the map will not be used.

3. Up to four class-based entries can be configured on a particular QOS map set that is applied to an

interface. Up to sixteen class-based entries can be configured in the box (four entries on four QOS

maps).

Usage Examples

The following example sets bandwidth of the QoS map to 10 Mbps:

(config)#qos map 1

(config-qos- map 1)#bandwidth 10000