ADTRAN 1000R Series spanning-tree priority <value>

Command Reference Guide Frame Relay Sub-Interface Config Command Set

spanning-tree priority <value>

Use the spanning-tree priority command to select the priority level of a port associated with a bridge. To

return to the default bridge-group priority value, use the no version of this command.

Syntax Description

<value> Priority value for the bridge group; the lower the value, th e higher the priori ty (valid

range: 0 to 255).

Default Values

Be default, the bridge-group priority value is set at 28.

Applicable Platforms

This command applies to the NetVanta 1000R, 3000, 4000, and 5000 and Total Access 900 Series units.

Command History

Release 1.1 Command was introduced.

Functional Notes

The only time that this priority level is used is when two interfaces with a path to the root have equal cost.

At that point, the level set in this command will determine which port the bridge will use. Set the priority

value lower to increase the chance the interface will be used.

Usage Examples

The following example sets the maximum priori ty on the Frame Relay sub-interface labeled 1.16 in bridge

group 17:

(config)#interface frame-relay 1.16

(config-fr 1.16)#spa n ni n g-tre e pri orit y 0