ADTRAN 1000R Series match

Command Reference Guide Quality of Service (QoS) Map Commands

match

Use the match command to specify which traffic should be processed by this QoS map. Possible variations

of this comman d inc l ud e:

match dscp <0-63>

match ip rtp <port #>

match ip rtp <first port # in range> <last port # in range>

match ip rtp <first port # in range> <last port # in range> all

match list <listname>

match precedence <0-7>

match protocol bridge

match protocol bridge netbeui

Syntax Description

dscp <0-63> Matches IP packets with the specified DSCP value.

ip rtp <start><end> all Matches RTP packets with even UDP destination port numbers in the

specified range (between start and end). If all (which is optional) is specified,

even and odd ports are matched in the specified range.

list <listname> Specifies the name of the acce ss-list ( ACL) you wish to u s e to match packets

for this QoS map. Refer to ip access-list extended <listname> on page 392 for

more information on creating access-lists.

precedence <0-7> Matches IP packets with the specified IP precedence value.

protocol bridge Matches frames being bridged by the router.

protocol bridge netbeui Matches only NetBEUI frames being bridged by the router.

Default Values

No default value is necessary for this command.

Applicable Platforms

This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900

Series units.

Command History

Release 6.1 Command was introduced.

Usage Examples

The following example assigns a traffic match pattern to the existing QoS map VOICEMAP:

(config)#qos map VOICEMAP 10

(config-qos-map)#match ip rtp 16384 20000