ADTRAN 1000R Series

Command Reference Guide Frame Relay Interface Config Command Set

snmp trap

Use the snmp trap command to enable all supported Simple Network Management Protocol (SNMP)

traps on the interface.

Syntax Description

No subcommands.

Default Values

By default, all interfaces (except virtual Frame Relay interfaces and sub-interfaces) have SNMP traps

enabled.

Applicable Platforms

This command applies to the NetVanta 1000R, 3000, 4000, and 5000 and Total Access 900 Series units.

Command History

Release 1.1 Command was introduced.

Release 3.1 Command was extended to the SHDSL interface .

Release 5.1 Command was expanded to includ e Ethernet su b-interfac es and Gigabit Ethe rnet

interfaces.

Usage Examples

The following example enables SNMP on the virtual Frame Relay inter face:

(config)#interface frame-relay 1

(config-fr 1)#snmp trap