Command Reference Guide ATM Sub-Interfa c e Config Command Set
61200510L1-35E Copyright © 2005 ADTRAN 717

ATM SUB-INTERFACE CONFIG COMMAND SET

To activate the ATM Interface Configuration mode, enter the interface atm command (and specify a
sub-interface) at the Global Configuration mode prompt. For example:
>enable
#
configure terminal
(config)#
interface atm 1.1
(config-atm 1.1)#
The following comm a nd s are com mo n to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
description <text> on page 31
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
access-policy <policyname> on page 718
bandwidth <value> on page 722
bridge-group <group#> on page 723
crypto map <mapname> on page 724
dial-backup commands begin on page 726
dynamic-dns [dyndns | dyndns-custom | dyndns-static] <hostname> <username>
<password> on page 742
encapsulation [aal5mux | aal5snap] on page 744
fair-queue <threshold> on page 745
hold-queue <queue size> out on page 746
ip commands begin on page 747
max-reserved-bandwidth <percent> on page 769
mtu <size> on page 770
oam retry <up-count> <down-count> <retry-frequency> on page 771
oam-pvc manage d <frequency> on page 772
pvc <VPI/VCI> on page 773
qos-policy out <mapname> on page 774
spanning-tree commands begin on page 776