ADTRAN 1000R Series area <area id> stub [no-summary]

Command Reference Guide Router (OSPF) Configuration Command Set
61200510L1-35E Copyright © 2005 ADTRAN 1304
area <area id> stub [no-summary]
Use the area stub command to configure an area as a stub area. Use the no form of this command to
disable stub-designation for areas defined as stubs using this command.
Syntax Description
<area id> Specifies an identifier for this stub area. Specifies as an integer (range: 0 to
4,294,967,295) or an IP address <A.B.C.D>.
no-summary
Optional. Designates the area as a total stub area. No summary link advertisements
will be sent by the ABR into the stub area.
Default Values
By default, OSPF is not enab le d.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 3.1 Command was introduced.
Technology Review
It is important to coordi nate configuration of all routers and access ser vers in the stub area . The area st ub
command must be configured for each of those pieces of equipment. Use the area router configuration
command with the area default-cost command to specify the cost of a default internal router sent into a
stub area by an ABR. Refer to area <area id> default-cost <value> on page 1302 for related informatio n.
Usage Examples
The following example configures area 2 as a stub area:
(config)#router ospf
(config-ospf)#area 2 stub