ADTRAN 1000R Series

Command Reference Guide Tunnel Configuration Command Set

ip ospf

Use the ip ospf command to customize OSPF settings (if needed).

Syntax Description

authentication-key

Specifies a simple-text authentication password to be used

by other routers using <password> the OSPF simple

password authentic at ion .

cost <value> S pecifies the OSPF cost of sending a packet on the interface.

This value overrides any computed cost value.

Range: 1 to 65,535.

dead-interval

<seconds> Sets the maximum interval allowed between hello packets. If

the maximum is exceeded, neighboring devices will

determine that the device is down. Range: 0 to 32,767.

hello-interval

<seconds> Specifies the interval between hello packets sent on the

interface. Range: 0 to 32,767.

message-digest-key <keyid> md5 <key>

Configures OSPF Message Digest 5 (MD5) authentication

(16-byte max) keys.

priority

<value> Set the OSPF priority. The value set in this field helps

determine the designated router for this network.

Range: 0 to 255.

retransmit-interval <seconds> Specifies the time between link-state advertisements (LSAs).

Range: 0 to 32,767.

transmit-delay

<seconds> Sets the estimated time required to send an LSA on the

interface. Range: 0 to 32,767.

Default Values

retransmit-interval <seconds> 5 seconds

transmit-delay <seconds> 1 second

hello-interval <seconds> 10 seconds: Ethernet, point-to-point, Frame Relay, Tunnel,

and PPP

dead-interval <seconds> 40 seconds

Applicable Platforms

This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900

Series units.

Command History

Release 3.1 Command was introduced.

Release 9.1 Command was expanded to include tunnel interfaces.