Chapter 8 Interface Configuration
SRP Interface Side Configuration
Step 3 Click on the Alarms tab, if required.
Figure 8-10 SRP Side Configuration window—Alarms tab
Configuring a SRP Side
To configure a SRP Side, proceed as follows:
Step 1 Launch the SRP Interface Side Configuration window. Refer to Table
Step 2 Choose a Chassis, Module, SRP Interface and SRP Side from the lists displayed at the left side of the window.
Step 3 Edit the parameters displayed in the General and Alarm tabs, as required. See “SRP Interface Side Configuration
Step 4 Click Save to save your configuration changes.
Cisco 12000/10700 v3.1.1 Router Manager User Guide
|
| ||
|
|
