7-8
Cisco 12000/10700 v3.1.1 Router Manager User Guide
OL-4455-01
Chapter 7 Interface Profiles
Creating an ATM Interface Profile
NSAP (Network Service Access Point) Address-Specify the NSAP address. Not applicable for Cisco
12000/10 720 Rout er M ana ger.
Maximum Active VCI Bits—Not app lica ble fo r Ci sco 12000 /1 072 0 Rout er Ma nage r.
Clock Source —Source of the clock.
ILMI Config ura tion
The ILMI C onfigurat ion a re a c onta ins t h e following fields:
Keepalive Time—The amount of time that should elapse between successive ILMI keepalive messages
sent on this int erface. A value of 0 disables IL MI keepalive messages on th is interface.
Auto-Configuration—You can enable or disable the ILMI link and interface type determination. The
configuration takes effect only on the next interface restart.
Address Regist ration—You can en able or disable IL MI Addre ss Registration on this inter face. The
configuration takes effect only on the next interface restart.
Configuration—Enable or di sabl e I LMI co nfigurat ion on thi s int erface. T he c onfigura tio n ta kes effect
only on the next interface restart. Disabling this object will also disable address reg istration,
auto-configuration, and keepalive time.
Trap—Allows you to enable or disable the ILMI traps.
Actions
Create Profile—C hoos e Crea te Profile to create a new p rofile.
Configuration (2) Tab
The Configuration (2) tab displays three areas: Information Element Transfer, Physical layer and
DS1/E1/DS3/E3.
Information Element Layer
Not appl ic abl e t o C isco 120 00/ 10720 R out er M ana ger.
Physical Layer
Not appl ic abl e t o C isco 120 00/ 10720 R out er M ana ger.
DS1/E1/DS3/E3
Line Buildou t—Not appl icabl e t o Ci sco 120 00/10 720 Ro uter M ana ger.
Framing Mode—T he f ra min g fo rm at pre se nt on the physic al int erface .