Cisco Systems 12000/10700 V3.1.1 Com m and Log Wind owDetailed Descri ption

4-28

Cisco 12000/10700 v3.1.1 Router Manager User Guide

OL-4455-01

Chapter 4 Managing Chassis

Command Log

Step 3 Scroll through the list of event commands, using the arrow bars, until the relevant event command

appears.

Note You can alter the width of the columns displayed in the table. See “Changi ng Co l umn Width”

section on page 4-24 for further details. The More (arrow) button is not applicable in this

window.

Com m and Log Wind ow—Detailed Descri ption

The Command Log window displays a single Command Log Details tab.

The Command Log Details tab (see Figure 4-14 on p age 4-2 7) displ ays a Comma nd Log Deta ils table

and Event History Details area.

The Command Log Details table displays the following information:

Index—Arbitrary integer value to uniquely identify the listed events. When it reaches the maximum

value, th e agen t wra ps th e value back to 1 and can fl ush exist ing ent rie s

Time—Value of system up time when the event occurred.

Comm and Source —Source of th e comma nd that in stiga ted the ev en t. You will see eith er com mand Line

or SNMP.

Config Source—Configuration data source for the event.

Config Destination—Configuration data destination for the event.

Terminal Type—When the command source field is set to command line, the terminal type appears

(unknown, co nsole, ter minal , virtual or auxi liary). Otherw ise, not applic able ap pear s.

Terminal Number—When the command source field is set to command line, the terminal number

appears. When the terminal is not available or not applicable, -1 appears.

Terminal User—When the command source is set to command line, the name of the logged in user

appears. When the terminal type is not available or not applicable, the field appears empty.

Terminal Location—When the command source is set to command line, the hard-wired location of the

termin al or t he remo te host for a n incomi ng conn ection appear s. Wh en the ter mina l type is not a vailable

or not appli cable, the field appears em pty.

Command Source Address—When the terminal type field is set to virtual, the internet address of the

connected system appears. When the command source is set to SNMP, the internet address of the

requester appears.

V i rtual Host Name —When the termi nal type f ield is set to virtu al, the host name of the connected sy stem

appears. When the terminal type is not available or not applicable, the field appears empty.

Server Address— If Config Source (or) Config Destination field is 'networkTftp' or 'networkRcp', the

Internet address of the storage file server is displayed. The value is 0.0.0.0 if Conf ig Source (or) Config

Destination field is N/A.