Cisco Systems 12000/10700 V3.1.1 SRP Interface Side Configuration Window-Detailed Description

Chapter 8 Interface Configuration

SRP Interface Side Configuration

SRP Interface Side Configuration Window—Detailed Description

The SRP Interface Side Configuration window has two tabs namely: General, and Alarms

General Tab

The General tab displays three areas: General, SONET Overhead and IPS SONET.

General

The General area allows you to configure the following information:

Clock Source—Allows you to configure the clock source from available options. This can either be internal (within the device) or Line (the network clock).

Loopback—Allows you to configure the loopback mode. It indicates the loopback mode for the SRP Side. The available options are: Disabled, Internal or Line

Framing—Allows you to configure SDH or SONET type framing. It indicates the framing mode of the side.

IPS Management Request Mode—Allows you to configure the IPS management request mode for the side. The available options are: noRequest, forced-switch, manual-switch, waitToRestore, signalDegrade, and signalFail.

Note The waitToRestore, signalDegrade and SignalFail modes cannot be set for the Interface, however the user can view the values as they are read-only values.

SONET Overhead

Path Signal Identifier—Allow you to configure the path signal identifier. The permissible values range from 0 to 255.

Section Trace Byte—Allows you to configure the section trace byte. The permissible values are 0 to 255.

Note If the device has pre-defined default values for the Path Signal Identifier and Section Trace Byte parameters, the same values are displayed in this area when the window is opened.

IPS SONET

Protected—Allows you to configure the Protected mode. The available options are: enable and disable

SD Threshold <3-9> (in 10e-)—Allows you to select the Signal Degrade threshold value in 10e-, between 3-9

SF Threshold <3-9> (in 10e-)—Allows you to select the Signal Fail BER threshold value in 10e-, between 3-9

Cisco 12000/10700 v3.1.1 Router Manager User Guide

8-26 OL-4455-01