Cisco Systems 12000/10700 V3.1.1 manual BGP Configuration, ATM Sub-Interface Configuration, 21-5

Chapter 21 Troubleshooting and FAQs

Configuration

You will see the following entries related to the Syslog configuration:

logging history size 10

logging history debugging

logging trap debugging

show logging history

This provides summary information on the logging facilities, the number of messages sent/dropped, etc.

Syslog can be configured from the Cisco 12000/10720 Router Manager. Right click on the chassis object and select the Fault > Syslog Messages option. You can configure the following Syslog options:

–Maximum Table Entries—Displays the upper limit on the number of entries that the area can contain.

–Minimum SysLog Severity—Any message with a severity less than this one will be ignored by the agent. This field can be set to emergency, alert, critical, error, warning, notice, info, or debug.

–Notifications Enabled—Displays whether Syslog SNMP notifications are enabled or not enabled.

BGP Configuration

Q.The GSR is configured for BGP but the BGP Configuration GUI displays ERROR on most of the settings. The GSRs

Decommissioned then commissioned GSRs again. Settings are seen on BGP Configuration GUI.

A.Make sure you have IOS Login and Enable passwords configured in the EMS. Right click on the chassis object and choose Configuration > Management Information. You configure the passwords on the IOS/Command Line Security tab.

ATM Sub-Interface Configuration

Q.Where do I find ATM sub-interface configuration? The ATM Interface Configuration GUI gives no such information.

A.VCLs, SVCs, and VLANs are only shown under the Component Managed View not the Physical View. In order to invoke the ATM VCL Configuration window, go to the Component Managed View, then right-click on a selected interface, then choose Cisco 12000/10720 Manager > Configuration > ATM > VCL Configuration.

ATM IP Configuration GUI Display ERROR Settings

Q.Though we have the ATM IP settings for an ATM port on the ATM IP Configuration GUI, it displays ERROR for all settings.

A.Make sure you have IOS Login and Enable passwords configured in the Cisco 12000/10720 Router Manager. Right click on the chassis object and choose Configuration > Management Information. Choose the IOS/Command Line Security tab.

Cisco 12000/10700 v3.1.1 Router Manager User Guide

OL-4455-01 21-5