4-26
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter4 Configuring VISM Features
Configuring VISM Features
Step 10 Type the cnfds0localcas command, line-num, ds0-num, local-cas-enable, and local-cas-pattern
argument values, and press Enter to configure a local CAS bit pattern for a T1 line and DS0.
Note The cnfds0localcas command is not allowed if the line is E1 or not enabled, or the DS0 is in
a remote loop state, or if the line signaling type is CAS.
Specify the arguments with the following values:
•line-num: 1 to 8 (T1 lines only)
•ds0-num: 1 to 24
•local-cas-enable:
–
1 = Enable
–
2 = Disable
•local-cas-pattern: In the range from 1 (default) to 15
Note If the local-cas-enable argument value = 1, you must specify a local-cas-pattern
argument value.
Step 11 Type the addcasvar command, var-name, file-name and |source| argument values, and press Enter to
add a CAS variant to your VISM card.
Note A file containing the CAS variant information must be downloaded to your MGX 8000 Series
PXM card using a separate application (TFTP) before you can execute this command.
Specify the arguments with the following values:
•var-name (name of the CAS variant): A text string of 1 to 64 alphanumeric characters.
•file-name:
–
wink_did_dod.o = wink start
–
ground_start.o = ground start
–
wink_did_dod_mf.o = wink start multifrequency
–
q50.o = Q.50
–
fgd_ea_incoming.o = for endpoints connected to an end office
–
fgd_ea_outgoing.o = for endpoints connected to an access carrier
–
fgd_os_e911.o = for endpoints connected to FDG OSS (Feature group D ope rator ser vices
system.
–
loop_start.o = loop start
–
delay_did_dod.o = dial delay, DTMF
–
delay_did_dod_mf.o = dial delay, MF
–
immed_did_dod.o = immediate start
–
immed_did_dod_mf.o = immediate start, MF
–
In the range from 1 to 32 alphanumeric characters—user configured files only.