Contents
vi
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Configuring ECAN 4-29
Configuring Jitter 4-30
Configuring PNNI for AAL1/AAL2 SVCs 4-31
Configuring the ATM Network Side 4-31
Configuring PVC Connections for All Operating Modes 4-32
Configuring VoIP Switching/Trunking Operating Mode Parameters 4-34
Configuring AAL2 Trunking Operating Mode Parameters 4-36
Configuring Switched AAL2 PVC Operating Mode Parameters 4-38
Configuring the Call Agent Interface 4-44
Configuring Domain Names and IP Addresses 4-45
Setting Up Call Agents and Protocols 4-45
Configuring Gateway Control Protocols 4-47
Configuring ISDN PRI Backhaul 4-49
Configuring Additional VISM Features 4-52
Mid-Call DTMF 4-55
Configurable Jitter Buffer 4-55
Adjustable Gain 4-55
Adjustable Music On-Hold Threshold 4-55
CALEA 4-55
MGC Redundancy 4-55
External DNS 4-56
2 IP Address Support 4-56
VoIP Trunking 4-56
T.38 Fax Relay 4-57
CAS Feature Enhancements 4-57
Programmable Tone Plans 4-57
Loop Start, DID, and Delay Dial 4-58
FGD 4-58
Configure Flash Hook and Glare Condition Attributes 4-59
Configure ANI and DNIS Digit Order 4-59
RFC 3064 Package Support 4-59
RFC 2833 Support 4-59
VISM Network Continuity Test 4-59
Configure PVC OAM Cell Parameters 4-60
PXM1E and PXM45 Card-Only Features 4-60
Call Agent-Controlled VoATM AAL1 and AAL2 SVC 4-61
AAL1 SVC-Based TDM Hairpinning 4-61
High Complexity Codec Support for VISM- PR—G.723.1 4-61
Announcement File System 4-62
Announcement Timeouts 4-62