5-23
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
addendpts
Command Modes VoIP switching/trunking, switched AAL2 PVC, AAL2 trunking, and switched ATM AAL1 SVC
Usage Guidelines
Note If you are running a VoIP application, you must use the cnfvismip command before you can add
endpoints.
This command adds a specified number of consecutive endpoints starting at a sp ecified endpoint number,
line number, and DS0 number. As endpoints are added, the command uses the next available (not added)
endpoint numbers and DS0s. The command does not wrap around D S0 and e ndp oint num bers.
Note The endpoint number is not equal to the DS0 number of the associated time slot. For example,
endpoint 1 could be associated with DS011.
Ensure that there are enough lines and DS0s before you add endpoints with this command. If you attempt
to add more endpoints than are available, only the available endpoints are added. For example, if T1 line
1 is the only line enabled and you attempt to add 25 endpoints, only 24 endpoints are added. Your
terminal display shows the actual number of endpoints added.
start-ds0-num DS0 number to which the endpoints are added. It can be a value from one of the
following ranges:
•1 to 24 for T1 lines
•1 to 31 for non-CAS E1 lines
•1 to 15 and 17 to 31 for CAS E1 lines
endpt-quantity The quantity of endpoints added. It can be a value from one of the following
ranges:
•For template number 1:
–
For VISM, from 1 to 145
–
For VISM-PR T1, from 1 to 192
–
For VISM-PR E1, from 1 to 248
•For template number 2:
–
For VISM T1, from 1 to 192
–
For VISM E1, from 1 to 248
•For template number 3:
–
For VISM, from 1 to 120
–
For VISM-PR T1, from 1 to 192
–
For VISM-PR E1, from 1 to 248
•For template number 4:
–
For VISM-PR, from 1 to 144