5-415
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
dsprudptrunk
dsprudptrunk
To display the configuration data of a specified ISDN PRI backhaul Reliable User Datagram Protocol
(RUDP) session, use the dsprudptrunk command in the VoIP switching/trunking operating mode.
dsprudptrunk session-num
Syntax Description
Command Modes VoIP switching/trunking
Usage Guidelines Follow standard CLI procedures for this command.
Examples The following example shows that the configuration data of ISDN PRI backhaul RUDP session number
43 is displayed:
dsprudptrunk 43
Session Number :43
Local Port :1124
.
.
Trans State Timeout:2000
Related Commands
session-num Identifying session number in the range from 1 to 64.
Command Description
addlapdtrunk Adds an LAPD trunk to a specific VISM card line.
addrtpcon Adds a static RTP VoIP trunking connection.
addrudptrunk Adds an ISDN PRI backhaul RUDP session for an LAPD trunk connection.
clrrtpcnt Clears the RTP counters (statistics) for a specific static RTP connection.
cnflapdtrunkpvc Assigns the PVC trunk type that carries LAPD messages for the current VISM
card.
cnflntrunkcond Enables or disables line conditioning on a VISM card line if a network alarm
is encountered.
cnfrtpcon Modifies an existing static RTP VoIP trunking connection.
cnfrudptrunkrmtip Modifies the remote IP address of VISM used in the ISDN PRI back haul R UDP
trunk for a specified session.
dellapdtrunk Deletes an LAPD configured line.
delrtpcon Deletes a static RTP VoIP trunking connection.
delrudptrunk Deletes an ISDN PRI backhaul RUDP session that is associated with an LA PD.
dsplapd Displays data about an LAPD.
dsplapdtrunkpvc Displays the assigned PVC trunk type that carries LAPD trunk messages for
the current VISM card.
dsplapdtrunks Displays the configuration data of all LAPD trunks.