5-89
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
cnfcascode
cnfcascode
To configure channel associated signaling (CAS) idle cod e an d seized code parameters for an endpoint,
use the cnfcascode command in the AAL2 trunking opera ting m ode .
cnfcascode endpt-num idle-code seized-code |endpts-num |
Syntax Description endpt-num The endpoint number which is to be configured with CAS idle code and seized code
values. It can be a value from one of the following ranges:
•For template number 1:
–
For VISM, from 1 to 145
–
For VISM-PR T1, from 1 to 192
–
For VISM-PR E1, from 1 to 248
•For template number 2:
–
For VISM T1, from 1 to 192
–
For VISM E1, from 1 to 248
•For template number 3:
–
For VISM, from 1 to 120
–
For VISM-PR T1, from 1 to 192
–
For VISM-PR E1, from 1 to 248
•For template number 4:
–
For VISM-PR, from 1 to 144
Note If the second (optional) endpt-num argument is specified, this argument v alue
is the first endpoint in a consecutive number of endpoints.
idle-code The 4-bit idle code. The value can be in the range from 0 to 15 and represents the four
signaling bits—A, B, C, and D—in binary, as bits 3, 2, 1, and 0 respectively, with bit
3 the most significant.