5-67
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
cnfaal2timerparams
cnfaal2timerparams
To configure the holdover time for VAD in milliseconds before activating silence suppression on an
AAL2 PVC, use the cnfaal2timerparams command in the switched AAL2 PVC operating mode.
cnfaal2timerparams vad-init-timer cid-fill-time
Syntax Description
Command Modes Switched AAL2 PVC
Usage Guidelines If AAL2 subcell multiplexing is disabled with the cnfaal2subcellmuxing command, executing this
command produces no affect.
Examples The following example shows that the VAD holdover timer is set for 500 ms, and will wait up to 50 ms
for a cell to fill when the next packet is not ready:
cnfaal2timerparams 500 50
Related Commands There are no related commands.
vad-init-timer The VAD holdover timer (defined in milliseconds) in the range from 250 to 65535.
cid-fill-timer Maximum wait time for cell content filling when the next packet is not ready
(defined in milliseconds), in the range from 5 to 100.