5-206
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
cnfsesmaxseg
cnfsesmaxseg
To configure the maximum segment size, in octets, that can be received by a VISM card after sending a
synchronize message, use the cnfsesmaxseg command in t he VoIP switching/trunking operatin g mode .
cnfsesmaxseg session-num seg-size
Syntax Description
Command Modes VoIP switching/trunking
Usage Guidelines Use this command for a previously added PRI backhaul session.
Examples The following example shows that a maximum 1000-octet segment size is configured for sessio n number
2:
cnfsesmaxseg 2 1000
Related Commands
session-num Identifying session number in the range from 1 to 64.
seg-size Maximum segment size, in octets, that ca n be rec ei v e d by a VISM card af ter
sending a synchronize message. It can be in the range from 30 to 65535.
Command Description
cnfsesack Configures the timeout period before sending an acknowledgment, and t he
maximum number of acknowledgments that can be accumulate d.
cnfsesmaxreset Configures the maximum number of resets that a VISM card performs before
a connection is reset.
cnfsesmaxwindow Configures the maximum number of segments (window) that can be sent
before receiving an acknowledgment.
cnfsesnullsegtmout Configures the idle time before sending a null segment.
cnfsesoutofseq Configures the maximum number of out-of-s equ ence packet s th at ca n be
accumulated before sending an EACK packet.
cnfsesport Configures the port numbers of a previously added PRI backhaul session.
cnfsesretrans Configures the timeout period for unacknowledged packets and the number
of retransmissions.
cnfsesstatetmout Configures the number of milliseconds that VISM waits for a transfer state
before executing an auto reset.
cnfsessyncatmps Configures the maximum number of call agent synchronization attempts.