4-18
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter4 Configuring VISM Features
Configuring VISM Features
Add and Configure DS1 Lines and DS0 Endpoints
Complete the following steps to add and configure a DS1 line and DS0 endpoints:
Step 1 Type the addendpt command, endpt-num, ds1-num, and ds0-num argument values, and press Enter to
add a DS1 line and a DS0 endpoint. This step ensures that a call with a specified endpoint is tied to a
specific line and channel. Specify the arguments with the following values.
Note If you choose CAS signaling for a VISM/VISM-PR E1 line, the supported operati ng modes
are AAL2 trunking and VoIP trunking.
•endpt-num:
–
For template number 1:
For VISM, in the range from 1 to 145
For VISM-PR T1, in the range from 1 to 192
For VISM-PR E1, in the range from 1 to 248
–
For template number 2:
For VISM T1, in the range from 1 to 192
For VISM E1, in the range from 1 to 248
–
For template number 3:
For VISM, in the range from 1 to 120
For VISM-PR T1, in the range from 1 to 192
For VISM-PR E1, in the range from 1 to 248
–
For template number 4:
For VISM-PR, in the range from 1 to 144
•ds1-num: The physical line number in the range 1 to 8
•ds0-num:
–
For T1 lines, from 1 to 24
–
For non-CAS E1 lines, from 1 to 31
–
For CAS E1 lines, from 1 to 15 and 17 to 31
Note You must specify DS0 16 for E1 lines if your application requires CAS signaling.
Step 2 Type the addendpts command, start-endpt, start-line-num, start-ds0-num, and endpt-quantity argument
values, and press Enter to add a number of endpoints in one command. Specify the arguments with the
following va l ues:
•start-endpt:
–
For template number 1:
For VISM, in the range from 1 to 145
For VISM-PR T1, in the range from 1 to 192
For VISM-PR E1, in the range from 1 to 248