5-212
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
cnfsesstatetmout
cnfsesstatetmout
To configure the number of milliseconds that VISM waits for a transfer state before executing an auto
reset, use the cnfsesstatetmout command in the VoIP switching/trunking operating mode.
cnfsesstatetmout session-num tstate-tout
Syntax Description
Command Modes VoIP switching/trunking
Usage Guidelines Use this command for a previously added PRI backhaul session.
Examples The following example shows that session number 2 is configured with a 500-ms transfer state timeout:
cnfsesstatetmout 2 500
Related Commands
session-num Identifying session number in the range from 1 to 64.
tstate-tout Transfer state timeout. The maximum number of milliseconds that VISM
waits for a transfer state before executing an auto re set. It can be i n the ra nge
from 0 to 65535. (Default = 2000)
Command Description
cnfsesack Configures the timeout period before sending an acknowledgment, and t he
maximum number of acknowledgments that can be accumulate d.
cnfsesmaxreset Configures the maximum number of resets that a VISM card performs before
a connection is reset.
cnfsesmaxseg Configures the maximum segment size, in octets, that can be re ce ived by a
VISM card after sending a synchronize message.
cnfsesoutofseq Configures the maximum number of out-of-s equ ence packet s th at ca n be
accumulated before sending an EACK packet.
cnfsesport Configures the port numbers of a previously added PRI backhaul session.
cnfsesretrans Configures the timeout period for unacknowledged packets a nd nu mber of
retransmissions.
cnfsessyncatmps Configures the maximum number of call agent synchronization attempts.