5-35
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
addrscprtn
addrscprtn
To add a resource partition for a virtual port, use the addrscprtn command in the VoIP
switching/trunking, switched AAL2 PVC, AAL2 trunking, AAL1 SVC, AAL2 SVC, a nd A AL1 /VoIP
(for TDM grooming) operating modes.
addrscprtn control-id
Syntax Description
Command Modes VoIP switching/trunking, switched AAL2 PVC, AAL2 trunking, AAL1 SVC, AAL2 SVC, and
AAL1/VoIP (for TDM grooming)
Usage Guidelines You must configure a virtual port with the addport command before you use this comm an d.
Note If the VISM card is reset after executing an addport command but before using this command, an
error message is displayed. The error has no effect on the system and can be ignored.
If you are using a PXM1 card, this command adds an entry with resource partition num ber 1. If you are
using a PXM1E card, this command adds the entries with resource partition numbers 225 and 2,
respectively.
Examples The following example shows that a resource partition is added to controller number 2:
addrscprtn 1
Related Commands
control-id The controller identification number to which the resource partition is added. It can
be one of the following:
•1—for a PXM1 card
•2—for a PXM1E or PXM45 card
•In the range from 3 to 255
Command Description
delrscprtn Deletes a resource partition.
dsprscprtn Displays information about a resource partition.