5-220
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
cnft38nsetimeout
cnft38nsetimeout
To configure a specified line with a length of time in which to wait for a remot e ackn owledgment of the
offer to switch to fax transfer mode, use the cnft38nsetimeout command in the Vo IP switching/tru nking
operating mode.
cnft38nsetimeout line-num nse-ack-timer
Syntax Description
Command Modes VoIP switching/trunking
Usage Guidelines Follow standard CLI procedures for this command.
Examples The following example shows that line number 2 is configured with an NSE acknowledgment timeout
value of 600 ms:
cnft38nsetimeout 2 600
Related Commands
line-num Line number of the channel, in the range from 1 t o 8.
nse-ack-timer Named Signaling Event (NSE) acknowledgment timeout value (defined in
milliseconds). It can be in the range from 250 to 10000, in increments of 250.
Command Description
cnfcodectmpl Assigns a codec template to an entire VISM card.
cnft38fxlco Configures the fax handling instructions for a specified line.
cnft38params Configures the T.38 fax transfer parameters for a specified line.
dspcodectmpls Displays all entries in the codec template table.
dspt38fxlco Displays the fax handling instructions configured for a specified line.
dspt38fxlcos Displays the fax handling instructions for all lines on the current VISM card.
dspt38nsetimeout Displays a specified configured line with a length of time in which to wait for
a remote acknowledgment of the offer to switch to fax transfer mode.
dspt38nsetimeouts Displays all configured lines with a length of time in which to wait for a remote
acknowledgment of the offer to switch to fax transfer mode.
dspt38params Displays the T.38 fax transfer parameters for a specified line.