5-365
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
dsplndsp
dsplndsp
To display the digital signal processor (DSP) data for a specified T1 or E1 line, use the dsplndsp
command in the VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking operating modes.
dsplndsp line-num
Syntax Description
Command Modes VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines Follow standard CLI procedures for this command.
Examples The following example shows that the DSP data for line 1 are displayed:
dsplndsp 1
VismLineNum: 1
ECANEnable: enable
ECANReenable: ReenableOnModemData
ToneDisable: G.165
MaximumTail: 32 milliseconds
ResidualEcho: ComfortNoise
VoiceDetection: Enable
Note VAD and ECAN apply to the VoIP switching/trunking operating mode only.
Related Commands
line-num Line number for which you want to display the DSP data. It can be in the range from
1 to 8.
Command Description
addln Adds a T1 or E1 line to a VISM card.
delln Deletes a T1 or E1 line from a VISM card.