5-34
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
addport
addport
To add a virtual port between the VISM and PXM cards, use the addport command in the VoIP
switching/trunking, switched AAL2 PVC, AAL2 trunking, AAL1 SVC, AAL2 SVC, a nd A AL1 /VoIP
(for TDM grooming) operating modes.
addport
Syntax Description This command has no arguments.
Command Modes VoIP switching/trunking, switched AAL2 PVC, AAL2 trunking, AAL1 SVC, AAL2 SVC, and
AAL1/VoIP (for TDM grooming)
Usage Guidelines This command automatically associates the VISM card and the virtual port with the MGX 8000 Series
platform.
Note If the VISM card is reset after executing this command but before executing the addrscprtn
command, an error message is displayed. The error has no effect on the system and can be ignored.
The port number is set to one of the following when y ou use thi s co mmand :
•1—for PXM1 cards
•255—for PXM1E cards
Examples The following example shows that a virtual port has been a dded be twee n the V ISM a nd PXM car ds:
addport
Related Commands Command Description
delport Deletes a VISM port on the packet network side.