5-407
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
dsprtpcnt
dsprtpcnt
To display the bearer counters (statistics) for a specific Real-Time Transport Protocol (RTP) VoIP
trunking connection, use the dsprtpcnt command in the VoIP switching/trunking and VoIP and switched
ATM AAL1 SVC operating modes.
dsprtpcnt conn-num
Syntax Description
Command Modes VoIP switching/trunking and VoIP and switched ATM AAL1 SVC
Usage Guidelines Follow standard CLI procedures for this command.
Examples The following example shows that the bearer counters (statistics) for the static RTP connection number
132 are displayed:
dsprtpcnt 132
Connection Index :132
Packets Sent :99604
Packets Received :0
Octets Sent :7966804
Octets Received :0
Packets Lost :0
Related Commands
conn-num Connection identification number. It can be in the range from 1 to 248.
Command Description
addlapdtrunk Adds an LAPD trunk to a specific VISM card line.
addrtpcon Adds a static RTP VoIP trunking connection.
addrudptrunk Adds an ISDN PRI backhaul RUDP session for an LAPD trunk connection.
clrrtpcnt Clears the RTP counters (statistics) for a specific static RTP connection.
cnflapdtrunkpvc Assigns the PVC trunk type that carries LAPD messages for the current VISM
card.
cnflntrunkcond Enables or disables line conditioning on a VISM card line if a network alarm
is encountered.
cnfrtpcon Modifies an existing static RTP VoIP trunking connection.
cnfrudptrunkrmtip Modifies the remote IP address of VISM used in the ISDN PRI back haul R UDP
trunk for a specified session.
dellapdtrunk Deletes an LAPD configured line.
delrtpcon Deletes a static RTP VoIP trunking connection.
delrudptrunk Deletes an ISDN PRI backhaul RUDP session that is associated with an LA PD.
dsplapd Displays data about an LAPD.