5-210
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
cnfsesport
cnfsesport
To configure the port numbers of a previously added PRI backhaul session, use the cnfsesp ort command
in the VoIP switching/trunking operating mode.
cnfsesport session-num local-port-num remote-port-num
Syntax Description
Command Modes VoIP switching/trunking
Usage Guidelines Follow standard CLI procedures for this command.
Examples The following example shows that session number 4 is configured with local (VISM) por t number 1200
and remote (call agent) port number 1204:
cnfsesport 4 1200 1204
Related Commands
session-num Identifying session number in the range from 1 to 64.
local-port-num Local port number. The VISM port number used fo r the session. It can be in
the range from 1124 to 65535.
remote-port-num Remote port number. The call ag e nt po r t n um b er u s ed fo r the session. It can
be in the range from 1124 to 65535.
Command Description
cnfsesack Configures the timeout period before sending an acknowledgment, and t he
maximum number of acknowledgments that can be accumulate d.
cnfsesmaxreset Configures the maximum number of resets that a VISM card performs before
a connection is reset.
cnfsesmaxseg Configures the maximum segment size, in octets, that can be re ce ived by a
VISM card after sending a synchronize message.
cnfsesnullsegtmout Configures the idle time before sending a null segment.
cnfsesoutofseq Configures the maximum number of out-of-s equ ence packet s th at ca n be
accumulated before sending an EACK packet.
cnfsesretrans Configures the timeout period for unacknowledged packets and the number
of retransmissions.
cnfsesstatetmout Configures the number of milliseconds that VISM waits for a transfer state
before executing an auto reset.
cnfsessyncatmps Configures the maximum number of call agent synchronization attempts.