5-135
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
cnfdisctimers
cnfdisctimers
To specify the wait delay times for the disconnected procedure, restart in progress command—initial,
minimum, and maximum timer values—use the cnfdisctimers command in the VoIP switching/trunking,
switched AAL1 SVC, switched AAL2 SVC, switched AAL2 PVC, AAL2 trunking, VoIP and switched
ATM AAL1 SVC operating modes.
cnfdisctimers init-wait-time min-wait-time max-wait-time
Syntax Description
Command Modes VoIP switching/trunking, switched AAL1 SVC, switched AAL2 SVC, switched AAL2 PVC, AAL2
trunking, VoIP and switched ATM AAL1 SVC
Usage Guidelines You must use the cnfmgcgrpprotocol command and select the disconnect type method for Restart in
Progress commands before you can use this command.
Examples The following example shows that an initial disconnect waiting time of 30 seconds, a minimum
disconnect waiting time of 0 seconds, and a maximum disconnect waiting time of 120 seconds is
configured for the current VISM card:
cnfdisctimers 30 0 120
Related Commands
init-wait-time Initial disconnect waiting delay time (defined in seconds). In the range from 1 to
100.
min-wait-time Minimum disconnect waiting delay time (defined in seconds). In the range from 0
to 100.
max-wait-time Maximum disconnect waiting delay time (defined in seconds). In the range from 1
to 5000.
Command Description
addmgcgrpprotocol Associates a call agent redundancy group to a gateway control protocol.
cnfmgcgrpprotocol Configures call agent group protocol data.
cnfxgcppeer Configures the UDP port number used to send gateway-initiated messages to
the call agent.
delmgcgrpprotocol Deletes an MGCP from a specified call agent redundancy gr oup .
dspdisctimers Displays the Restart in Progress command disconnect type method wait
delay times.