5-409
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
dsprtpcon
dsprtpcon
To display the configuration data of a specified static Real-Time Transport Protocol (RTP) VoIP trunking
connection, use the dsprtpcon command in the VoIP switching/trunking and VoIP and switched ATM
AAL1 SVC operating modes.
dsprtpcon conn-num
Syntax Description
Command Modes VoIP switching/trunking and VoIP and switched ATM AAL1 SVC
Usage Guidelines Follow standard CLI procedures for this command.
Examples The following example shows that the configuration data for the static RTP connection number 106 is
displayed:
dsprtpcon 106
Connection Index :106
Endpoint Number :200
Local RTP Port :50000
Remote RTP Port :49650
Remote IP Address :nnn.nnn.nnn.nnn
Codec Type :G.729a
Packetization Period :20
ECAN Status :Enable
VAD :Enable
VAD Timer :300 ms
CAS Transport :On
DTMF Transport :On
ICS Enable :On
Triple redundancy :On
Bearer TOS :160
Connection Mode :GW can send and recv packets
Conn Alarm State :
Related Commands
conn-num Connection identification number. It can be in the range from 1 to 248.
Command Description
addlapdtrunk Adds an LAPD trunk to a specific VISM card line.
addrtpcon Adds a static RTP VoIP trunking connection.
addrudptrunk Adds an ISDN PRI backhaul RUDP session for an LAPD trunk connection.
clrrtpcnt Clears the RTP counters (statistics) for a specific static RTP connection.
cnflapdtrunkpvc Assigns the PVC trunk type that carries LAPD messages for the current VISM
card.
cnflntrunkcond Enables or disables line conditioning on a VISM card line if a network alarm
is encountered.