5-195
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
cnfrsvp
cnfrsvp
To configure Resource Reservation Protocol (RSVP) for a specified connection, use the cnfrsvp
command in the VoIP switching/trunking and VoIP and switched ATM AAL1 SVC operating modes.
cnfrsvp lcn rsvp-enable
Syntax Description
Command Modes VoIP switching/trunking, VoIP and switched ATM AAL1 SVC
Usage Guidelines Follow standard CLI procedures for this command.
Examples The following example shows that RSVP is enabled for LCN 146:
cnfrsvp 146 1
Related Commands
lcn The logical channel number. It can be in the range from 131 to 510.
rsvp-enable Enables or disables RSVP. It can be one of the following values:
•1 = On
•2 = Off
Command Description
cnfrsvprefreshmiss Configures the number of times VISM waits for a missed RSVP minimum
refresh message for a specified connection.
dsprsvpif Displays the RSVP status of a specified connection.
dsprsvpreq Displays the data associated with a specified RSVP request.
dsprsvpreqs Displays all RSVP-known requests on the current VISM card.
dsprsvpresv Displays all data associated with an RSVP bandwidth reservation.
dsprsvpresvs Displays all incoming RSVP-known reservations on the current VISM card.
dsprsvpsenders Displays all data associated with a specified RSVP path st ate.