5-205
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
cnfsesmaxreset
cnfsesmaxreset
To configure the maximum number of reset s that a VISM ca rd perf orms bef ore a con nection is reset, use
the cnfsesmaxreset command in the VoIP switching/trunking operating mode.
cnfsesmaxreset session-num max-resets
Syntax Description
Command Modes VoIP switching/trunking
Usage Guidelines Use this command for a previously added PRI backhaul session.
Examples The following example shows that 25 is the maximum number of resets configured for sessi on number 2:
cnfsesmaxreset 2 25
Related Commands
session-num Identifying session number in the range from 1 to 64.
max-resets Maximum number of resets that the VISM card performs before a
connection is reset. It can be in the range from 0 to 255. ( Defau lt = 3)
Command Description
cnfsesack Configures the timeout period before sending an acknowledgment, and th e
maximum number of acknowledgments that can be accumulated.
cnfsesmaxseg Configures the maximum segment size, in octets, that can be received by a
VISM card after sending a synchronize message.
cnfsesmaxwindow Configures the maximum number of segments (window) that can be sent
before receiving an acknowledgment.
cnfsesnullsegtmout Configures the idle time before sending a null segment.
cnfsesoutofseq Configures the maximum number of out-of-sequence packets that ca n be
accumulated before sending an EACK packet.
cnfsesport Configures the port numbers of a previously added PRI backhaul session.
cnfsesretrans Configures the timeout period for unacknowledged packets and the number
of retransmissions.
cnfsesstatetmout Configures the number of milliseconds that VISM waits for a transfer state
before executing an auto reset.
cnfsessyncatmps Configures the maximum number of call agent synchronization attempts.