5-208
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
cnfsesnullsegtmout
cnfsesnullsegtmout
To configure the timeout period, in milliseconds, of idle time before a null segment is sent, use the
cnfsesnullsegtmout command in the VoIP switching/trunking operating mode.
cnfsesnullsegtmout session-num null-seg-tout
Syntax Description
Command Modes VoIP switching/trunking
Usage Guidelines Use this command for a previously added PRI backhaul session.
Examples The following example shows that the idle timeout period is configured at 1000 ms for session nu mber 2:
cnfsesnullsegtmout 2 1000
Related Commands
session-num Identifying session number in the range from 1 to 64.
null-seg-tout Timeout period (defined in milliseconds) of idle time before a null segment
is sent. It can be in the range from 0 to 65535.
Command Description
cnfsesack Configures the timeout period before sending an acknowledgment, and t he
maximum number of acknowledgments that can be accumulate d.
cnfsesmaxreset Configures the maximum number of resets that a VISM card performs before
a connection is reset.
cnfsesmaxseg Configures the maximum segment size, in octets, that can be re ce ived by a
VISM card after sending a synchronize message.
cnfsesoutofseq Configures the maximum number of out-of-s equ ence packet s th at ca n be
accumulated before sending an EACK packet.
cnfsesport Configures the port numbers of a previously added PRI backhaul session.
cnfsesretrans Configures the timeout period for unacknowledged packets and the number
of retransmissions.
cnfsesstatetmout Configures the number of milliseconds that VISM waits for a transfer state
before executing an auto reset.
cnfsessyncatmps Configures the maximum number of call agent synchronization attempts.