5-50
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
cc
cc
To navigate from the current (logged on) card to another card in the MGX 8000 Series platform, use the
cc command in the VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking operatin g
modes.
cc slot-num
Syntax Description
Command Modes VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines Wh en you e xecute this command, the card residing in the slot identified by the slot-num value becomes
active and is identified in the command line prompt. If there is no card in the slot identified by the
slot-num value, an error message is displayed on your terminal.
Examples The following example shows that the card in slot 22 was active, and now the card in slot 11 is active:
node1.1.22.VISM.a > cc 11
node1.1.11.VISM.a >
Related Commands There are no related commands.
slot-num The slot number in the MGX 8000 Series platform that contains the card you want to
access and configure. It can be in the range from 1 to 32.