5-29
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
addlnloop
addlnloop
To set a specified line of the current card to th e lo cal loopback state, use the addlnloop command in the
VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking operating modes.
addlnloop line-num
Syntax Description
Command Modes VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines Follow standard CLI procedures for this command.
Note The VISM CLI has no specific command for setting a line to a remote loopback state. To set a line
to remote loopback state, use the cnfbert command on the PXM card. Refer to MGX 8000 Series
platform command line interface guides for more information.
Examples The following example adds a local line loopback state to line 1:
addlnloop 1
Related Commands
line-num Line number of the T1 or E1 line to be added in the range from 1 to 8.
Command Description
dellnloop Deletes a T1 or E1 local line loopback state for the VISM card.