5-324
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
dspcid
dspcid
To display the configuration data of an AAL2 channel identifier (CID) on the current VISM card, use
the dspcid command in the switched AAL2 PVC and AAL2 trunking operating modes.
dspcid lcn cid-num
Syntax Description
Command Modes Switched AAL2 PVC and AAL2 trunking
Usage Guidelines Follow standard CLI procedures for this command.
Examples The following example shows that the configuration data of the AAL2 CID ide nti fied by LCN 131 an d
CID 101 is displayed:
dspcid 131 101
LCN number : 131
CID number: 101
Endpoint number : 1
CidRowStatus: active
Type3redundancy: enabled
VAD: enabled
VADInitTimer: 250
Profile type: ITU
Profile number: 2
Codec type: G.711u
Cas transport: enabled
DTMF transport: enabled
Ecan on/off: enabled
ICS enable: Disabled
pkt period: 5
Cid state: Active
Related Commands
lcn The logical channel number of the LCN/CID pair in the range from 131 to 510.
cid-num The channel identification number of the LCN/CID pair in the range from 8 to 255.
Command Description
addcid Adds an AAL2 CID on a VISM card.
delcid Deletes the association between an endpoint and an LCN/CID pair.
dspcids Displays all AAL2 CIDs for a specified LCN on a VISM card.