4-48
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter4 Configuring VISM Features
Configuring VISM Features
•aal-conn-type:
–
1 = AAL1
–
2 = AAL2
–
3 = Not applicable
Note You must type 3 for the aal-conn-type argument if the network-type argument = 1.
Step 5 Type the addxgcppersistevt command, event-num and pkg-event argument values, and press Enter to
designate xGCP events as persistent.
Note Do not complete this step if persistent events are not required for your application.
Specify the arguments with the following values:
•event-num: In the range from 1 to 64.
•pkg-event:
–
r/co3 = VISM initiated AAL2 type 3 packet (CO3) network continuity test
–
r/co4 = Network continuity test detect
–
g/ft = Fax tone
–
g/mt = Modem tone
–
g/vbd = Voiceband data
–
g/vbdt = Voiceband data termination
–
l/hu, bl/hu = On hook
–
l/hd, blhd = Off hook
–
ms/ans, dt/ans, md/ans, mo/ans = Answer
–
ms/sup, dt/sup, md/sup = Setup
–
ms/rel, dt/rel, md/rel, mo/rel = Release
–
ms/rtc, dt/rlc, md/rlc, mo/rlc = Release complete
–
ms/res, dt/res, md/res = Resume
–
ms/sus, dt/sus, md/sus = Suspend
–
md/awk = Acknowledgment wink
–
mo/rbz = Reverse make bus y
Step 6 Type the cnfsrcppeer command, peer-num and udp-port-num argument values, and press Enter to
specify the SRCP parameters for communication between VISM and the call agent. Specify the
arguments from the following values:
•peer-num: The peer (call agent) identification number, as displayed in the dspsrcppeers command
list; in the range from 1 to 8.
•udp-port-num: In the range from 1025 to 65535
Note If you do not execute this command, the default MGCP/SGCP port number = 2428.