Cisco Systems (VISM) dspendpt

5-346

Cisco VISM Installation and Configuration Guide

Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004

Chapter5 CLI Commands

dspendpt

dspendpt

To display configuration data of a specified VISM card endpoint, use the dspendpt command in the VoIP

switching/trunking, switched AAL2 PVC, and AAL2 trunking operating modes.

dspendpt endpt-num

Syntax Description

Command Modes VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking

Usage Guidelines Follow standard CLI procedures for this command.

Examples The following example shows that the configuration data of endpoint number 120 is displayed:

dspendpt 120

EndptNum: 120

EndptLineNum: 1

EndptName: T1-1/1@cisco.com

EndptSpeed: 64 kbps

EndptState: active

EndptChannelMap: 1

EndptEnable: active

EndptLoopback: disabled

Note The EndptChannelMap value is represented by a hexadecimal number, where eac h DS0 is a power

of 2—EndptChannelMap = 2DS0 number.

endpt-num Endpoint number. It can be a value from one of the following ranges:

•For template number 1:

–

For VISM, from 1 to 145

–

For VISM-PR T1, from 1 to 192

–

For VISM-PR E1, from 1 to 248

•For template number 2:

–

For VISM T1, from 1 to 192

–

For VISM E1, from 1 to 248

•For template number 3:

–

For VISM, from 1 to 120

–

For VISM-PR T1, from 1 to 192

–

For VISM-PR E1, from 1 to 248

•For template number 4:

–

For VISM-PR, from 1 to 144