5-377
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
dsplntonetimeout
dsplntonetimeout
To display the configured timeout periods for all call progress tones of a specified VISM card line, use
the dsplntonetimeout command in the VoIP switching/trunking and switched AAL2 PVC operating
modes.
dsplntonetimeout line-num
Syntax Description
Command Modes VoIP switching/trunking and switched AAL2 PVC
Usage Guidelines Follow standard CLI procedures for this command.
Examples The following example shows that all call progress tones for the current VISM card line number 5 are
displayed, in seconds:
dsplntonetimeout 5
LineNum: 5
Dsx1RingingTO: 200 seconds
Dsx1RingBackTO: 200 seconds
Dsx1BusyTO: 35 seconds
Dsx1ReorderTO: 35 seconds
Dsx1DialTO: 16 seconds
Dsx1StutterDialTO: 16 seconds
Dsx1OffHookAlertTO: 5 seconds
Related Commands
line-num Line number for which you want to display the configured timeout periods
(defined in seconds) for all call progress tones. It can be in the range from 1 to
8.
Command Description
addtoneplan Adds a tone plan to the current VISM card.
cnflnringback Configures the ringback tone method for a specified line on the current VISM
card.
cnflntoneplan Assigns a tone plan to a specified VISM card line.
cnflntonetimeout Modifies the timeout periods of all call progress tones supported by VISM on
a specified VISM card line.
dellntoneplan Deletes the tone plan configuration of a specified VISM card line.
deltoneplan Deletes a previously added tone plan from the current VISM card.
dsplnringback Displays the ringback tone method for a specified line on the current VISM
card.
dsplntoneplan Displays the tone plan configuration of a specified VISM card line.
dsptonebuiltinplans Displays all preconfigured (built-in) tone plans on the current VISM card.