5-431
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
dspsrcppeer
dspsrcppeer
To display the peer configuration data for a specified Simple Resource Control Protocol (SRCP) peer
(call agent), use the dspsrcppeer command in the VoIP switching/trunking operating mode.
dspsrcppeer peer-num
Syntax Description
Command Modes VoIP switching/trunking
Usage Guidelines Follow standard CLI procedures for this command.
Examples The following example shows that the peer configuration data for the call agent identified by peer
number 4 is displayed:
dspsrcppeer 4
Related Commands
peer-num Peer (call agent) identification number. It can be a value from 1 to 8.
Command Description
dspsrcpcnt Displays the SRCP message counters (statistics) for a specified call agent.
dspsrcpcnts Displays SRCP message counters (statistics) for all known call agents.
dspsrcppeers Displays the peer configuration data for all known SRCP peers (call agents).
dspsrcpport Displays the local UDP port number used by the SRCP on VISM.
dspsrcpretry Displays the card level SRCP retransmission parameters—maximum number
of retransmission attempts, minimum timeout, and maximum timeout.