5-197
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
cnfrtcprepint
cnfrtcprepint
To configure the Real Time Control Protocol (RTCP) report interval for a VISM card, use the
cnfrtcprepint command in the VoIP switching/trunking and VoIP and switched ATM AAL1 SVC
operating modes.
cnfrtcprepint report-interval |report-mult|
Syntax Description
Command Modes VoIP switching/trunking and VoIP and switched ATM AAL1 SVC
Usage Guidelines Follow standard CLI procedures for this command.
Examples The following example shows that the RTCP report packet interval is configured at 1000 ms:
cnfrtcprepint 1000
Related Commands
report-interval Interval (defined in milliseconds) between RTCP report packets sent to peer VoIP
endpoints. It can be in the range from 500 to 1500, in inc rem en ts of 10 .
report-mult (Optional) Interval multiplier for the report-interval argument value. Use this
argument if you need to configure the report-interval argument value higher than
the maximum (1500 ms). It can be in the range from 1 to 10. (Default = 3)
Note If report-interval = 1500 and report-mult = 3, then 1000 * 3 = 4500. So,
the interval time between RTCP report packets sent to peer VoIP
endpoints is configured as 4500 ms.
Command Description
dspvismparam Displays current VISM card configuration.