5-143
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
cnfds0loop
cnfds0loop
To configure a loopback type for a specified line and DS0, use the cnfds0loop command in the VoIP
switching/trunking, switched AAL2 PVC, and AAL2 trunking operating modes.
cnfds0loop line-num ds0-num loopback-type
Syntax Description
Command Modes VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines Follow standard CLI procedures for this command.
Examples The following example shows that the loopback type of li ne 2, D S0 1 2 is c onfigured a s r em ote :
cnfds0loop 2 12 2
Related Commands There are no related commands.
line-num Line number of the channel to be configured for a l oopback type; in the range from
1 to 8.
ds0-num DS0 number of the channel to be configured for a loopback t ype . It can be a value
from one of the following ranges:
1 to 24 for T1 lines
1 to 31 for E1 lines
loopback-type The type of loopback to be used on the ch an nel. I t can be one o f the fo llowing
values:
1 = No loopback
2 = Remote loopback
3 = Local loopback