5-237
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
cnfxgcppeer
cnfxgcppeer
To configure the User Datagram Protocol (UDP) port number used to send gateway-initiated messages
to the call agent, use the cnfxgcppeer command in the VoIP switching/trunking and switched AAL2
PVC operating modes.
cnfxgcppeer mgc-num protocol-num remote-udp-pnum
Syntax Description
Command Modes VoIP switching/trunking and switched AAL2 PVC
Usage Guidelines Follow standard CLI procedures for this command.
Examples The following example shows that call agent 1 is configured with protocol number 3 and remote UDP
port number 1168:
cnfxgcppeer 1 3 1168
Related Commands
mgc-num A number by which the call agent is identified in the range from 1 to 8.
protocol-num Protocol number. It can be one of the following values:
•1 = MGCP 0.1
•2 = SGCP 1.1+
•4 = SGCP 1.5
•5 = MGCP 1.0
remote-udp-pnum UDP port number. In the range from 1025 to 65535. (Default = 2427)
Command Description
cnfdisctimers Specifies the wait delay times for the disconnected procedure, restart in
progress command—initial, minimum, and maximum timer values.
cnfmgcgrpprotocol Configures call agent group protocol data.
dspdisctimers Displays the Restart in Progress command disconnect type method wait delay
times.
dspxgcppeers Displays all UDP peer ports used by SGCP and MGCP.