5-351
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
dsplapd
dsplapd
To display configuration data about a Link Access Protocol D channel (LAPD), use the dsplapd
command in the VoIP switching/trunking operating mode.
dsplapd line-num ds0-num
Syntax Description
Command Modes VoIP switching/trunking
Usage Guidelines Follow standard CLI procedures for this command.
Examples The following example shows that the LAPD configuration data is displayed for line number 1, DS0
number 1:
dsplapd 1 1
vismRudpSessionStatNum: 1
vismRudpSessionAutoResets: 0
vismRudpSessionRcvdAutoResets: 0
vismRudpSessionRcvdInSeqs: 0
vismRudpSessionRcvdOutSeqs: 0
vismRudpSessionSentPackets: 5
vismRudpSessionRcvdPackets: 0
vismRudpSessionSentBytes: 0
vismRudpSessionRcvdBytes: 0
vismRudpSessionDataSentPkts: 0
vismRudpSessionDataRcvdPkts: 0
vismRudpSessionDiscardPkts: 0
Trunk type: Backhaul
Related Commands
line-num Line number of the channel for which you want to display the LAPD
configuration data. It can be in the range from 1 to 8.
ds0-num DS0 number of the channel for which you want to display t he L APD
configuration data. It can be a value from one of the following ranges:
•1 to 24 for T1 lines
•1 to 31 for E1 lines
Command Description
addlapd Adds an LAPD.
addlapdtrunk Adds an LAPD trunk to a specific VISM card line.
addrtpcon Adds a static RTP VoIP trunking connection.
addrudptrunk Adds an ISDN PRI backhaul RUDP session for an LAPD trunk connection.
clrrtpcnt Clears the RTP counters (statistics) for a specific static RTP connection.
cnflapdtrunkpvc Assigns the PVC trunk type that carries LAPD messages for the current VISM
card.