5-139
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
cnfdpvcoamparams
cnfdpvcoamparams
To configure the transmitted and received permanent virtual circuit (PVC) Operations, Administration,
and Maintenance (OAM) cell parameters, use the cnfdpvcoamparams command in the VoIP
switching/trunking, switched AAL2 PVC, and AAL2 trunking operating modes.
cnfdpvcoamparams cell-gap recov-cell-num unack-cell-num
Syntax Description
Command Modes VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines Follow standard CLI procedures for this command.
Examples The following example shows that the transmitted and received PVC OAM parameters are configured
with a 20 ms intercell gap, a 5-cell recovery indication cell count, and a 10-cell unac knowledge
indication cell count:
cnfdpvcoamparams 20 5 10
Related Commands
cell-gap Intercell gap—the time between cells (defined in milliseconds). It can be in
the range from 10 to 5000. (Default = 500)
recov-cell-num Recovery indication cell count—the number of cells that must be received
before a PVC is considered recovered from a failure. It can b e in t he ra nge
from 1 to 20. (Default = 3)
unack-cell-num Unacknowledge indication cell count—the number of cells that must be
unacknowledged before a PVC is declared as failed. It can be in the range
from 1 to 20. (Default = 5)
Command Description
dspdpvcoamparams Displays the transmitted and received PVC OAM cell parameters.